无锡跑步机(板链)生产线装配技术参考

一、 无锡跑步机（板链）生产线无锡跑步机总体要求

1、 无锡跑步机（板链）生产线无锡跑步机线体采用板式输送机作传动媒介,运行方式为连续慢流、节拍两种方法。

2、无锡跑步机（板链）生产线无锡跑步机 线体输送链条选用节距为100mm侧边带导向的单侧专用弯板链，链板采用δ=3镀锌板制作，宽度为100mm，线体支架选用60×40mm矩形方管，驱动涨紧装置选用槽钢制作。

3、无锡跑步机（板链）生产线无锡跑步机 线体两侧护边高于输送面板10-12mm左右，线体驱动采用台湾城邦减速机，线体运行要平稳，不得出现窜动现象，无异常噪音。

4、 无锡跑步机（板链）生产线无锡跑步机线体采用工位组合方式，在组装前对外露的金属材料表面均进行表面除锈、喷漆、烤漆处理，保证设备内地质量的可靠性及外型美观

1. General requirements of treadmill (plate chain) production line

1. Treadmill (plate chain) production line The treadmill line body adopts a plate conveyor as the transmission medium, and the operation mode is continuous slow flow and beat.

2. Treadmill (plate chain) production line treadmill. The conveyor chain of the line body is a single-sided special bent plate chain with a pitch of 100mm and the side belt is guided. The chain plate is made of δ=3 galvanized sheet, the width is 100mm, and the line body bracket A 60×40mm rectangular square tube is selected, and the drive tensioning device is made of channel steel.

3. Treadmill (plate chain) production line treadmill. The protective edges on both sides of the line body are about 10-12mm higher than the conveying panel. The line body is driven by a Taiwan city state reducer. The line body should run smoothly, without movement, and no abnormal noise. .

4. Treadmill (plate chain) production line The treadmill line body adopts the station combination method, and the surface of the exposed metal material is treated with surface rust removal, painting, and baking before assembly to ensure the reliability of the equipment inland quality and the beautiful appearance